What might be a good strategy to remove the stock XP-G LED on the DQG Ti AAA driver? I want to install a 219b. Please see this album:
I’m debating options:
- hot air from the LED side, but not sure how to keep the components on the bottom of the board from falling off… I do have some Kapton like tape, https://www.amazon.com/gp/product/B00W3FAFP0/ but it has almost no adhesive and does not stay in place.
Im wondering if “real” Kapton tape would stick better? Ive never tried it.
- Im debating using a soldering iron to heat the positive contact disc on the bottom of the driver, below the LED… same concerns about components falling off. I expect the positive contact disc would be the first thing to get desoldered.
brainstorming and suggestions welcome…
You must log in or register to comment.
How many components are on the bottom? If it’s just a few I’d go with the hot air and solder anything that falls off back on afterwards
Edit: I just saw the album lol. I say take good photos and go to town with the hot air. It wouldn’t take long even if you had to solder all those bottom side components back on
Adair21> go to town with the hot air
Thanks! I needed that little push of encouragement… really appreciate your input… Will post results after I take the leap.